CALICE test-beam meeting, 6 March 2006, UCL
Agenda:
09:30 coffee
Test-beam preparation
- 10:00-10:25 Position and angle resolution - A.-M. Magnan (ppt)
- 10:25-10:50 VFE calibration - C. Targett-Adams (pdf)
- 10:50-11:15 Online status - P. Dauncey (ppt)
- 11:15-11:40 Test-beam monitor - G. Mavromanolakis (pdf)
- 11:40-12:00 ECAL cosmics run - G. Gaycken (pdf)
- 12:00-12:25 Combined online plots and fast analysis - M. Groll (ppt)
12:25-13:25 Lunch
- 13:25-13:40 Electronic Logbook - S. Karstensen (ppt)
- 13:40-14:05 General HCAL plans - E. Garutti (ppt)
- 14:05-14:15 CERN test beam schedule - F. Sefkow (pdf)
- 14:15-15:30 Test-beam planning discussion, including ECAL task
list - N. Watson (pdf)
15:30-16:00 Coffee
Future work
- 16:00-16:15 Data paths on 1.5 m slab - M. Goodrick (pdf)
- 16:15-16:30 Glue and assembly - R. Thompson (ppt)
- 16:30-16:45 Thermal Simulation - S. Snow (ppt , back-up doc)
- 16:45-17:00 Endcap design - D. Bailey (ppt)
Directions:
The meeting will be held in room E7 on the ground floor of the
Department of Physics and Astronomy at University College London.
Details of how to get to the Department can be found
here. To get
to E7 it is easiest to enter UCL via Gower Place as indicated on the
campus map. The entrance to the physics building is in the corner,
up about 5 steps, on the left about 20 metres after the entrance to
UCL. After entering the doors walk past the post boxes and photos and
go through the next double doors. Turn right and room E7 is down the
corridor on the right-hand side.
Organisation:
Coffee and Lunch will be served in E7 at the times stated on the
agenda.
(Last updated on 28 February 2006) Comments to
Matthew Wing,
mw@hep.ucl.ac.uk