Proton Calorimetry/Experimental Runs/2018/Aug16

Beam tests of the UCL plastic scintillator range calorimeter.

Night of 15th to 16th of August 2018

Pre-data Taking Information and Notes

Sheet ordering from front to end (in beam direction): 31,25,24,23,20,16,12,11,9,8,6,5,4,3,2,1,30,29,28,27,26,22,19,18,17,15,14,13,10,7,21

100% beam intensity is about 10e6 particles per second

Set low full well mode using W000300000

Set high full well mode using W000300004

Baud rate has to be 115200. Also check that the serial port is enabled

Read full well mode using R0003

The sensor pixel dimensions are 1030 x 1536 which has to be set manually

The MedAustron Ripple filter used in this experiment has a WET of 3mm.

Data Taking

Run number	Full Well Mode	Beam Energy (MeV/u)	Intensity Degrader	Test type	Comments	Thumbnail
0	low	0	10%	background	two ripple filter in! have a WET of 3mm. until stated otherwise
1	low	184.5	10%	energy scan
2	low	184.5	10%	energy scan	repeat
3	low	184.5	10%	energy scan	repeat
4	low	400	10%	calibration RF	calibration shootthrough with ripple filters!
5	low	400	10%	calibration RF	repeat
6	low	154.5	10%	energy scan
7	low	146.5	10%	energy scan
8	low	138.3	10%	energy scan
9	low	121.1	10%	energy scan
10	low	120	10%	energy scan
11	low	0	10%	background	ripple filter out! Background
12	low	400	10%	calibration	calibration shootthrough
13	low	184.5	10%	energy scan
14	low	184.5	10%	energy scan	repeat
15	low	154.5	10%	energy scan
16	low	146.5	10%	energy scan
17	low	138.3	10%	energy scan
18	low	121.1	10%	energy scan
19	low	120	10%	energy scan
20	low	184.5	10%	radiation damage	check for radiation damage
21	low	184.5	10%	radiation damage	repeat