ELogs/MechanicalEngineering
Electronic Log for Mechanical Engineering
To Do
Proton Therapy
June 2021 - Prepare scintillator sheets to be adhered together using standard primer
November 2021 - Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea
February 2022 - Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped
May 2022- CAD Prototype a sliding system to mount multiple scintillator holders into a case
August 2022 - Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.
September 2022 - Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs
Radiotherapy
June 2022 - Initiated design of large Peli Case. Received Lab scissor jack used to mount camera.
July 2022 - Created CAD models for internal components including:
- Scintillator holder.
- 2x Side Vice faces.
- 1x Front Vice face.
- Cover for beam entry point.
These were printed soon after.
Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson.
Machined two special 1/4-20 UNC screws for camera mount.
Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel.
Completed
2022
Proton Therapy
February 2022 - Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped
May 2022- CAD Prototype a sliding system to mount multiple scintillator holders into a case
August 2022 - Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.
September 2022 - Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs
2021
- June
- Prepare scintillator sheets to be adhered together using standard primer
- November
- Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea