ELogs/SimonJolly: Difference between revisions

Revision as of 13:41, 4 August 2025

Electronic Log for Simon Jolly

Modify FMC daughterboard design with ZMOD connector — Pete Hastings (Oxford)/Andy Rose (Imperial)/Matt Warren.
Update DDC board design with improvements from Mark Jones (Oxford) and Duncan Parker (Imperial). Clarify spec with Marko Levicnik.
Shrink board to accept 1.5mm sheet spacing for Clatterbridge.
Update mechanical design of scintillator stack holder:
- Move to 4-sided readout.
- Potential for flex-rigid circuit design.
Contact Nuvia to discuss nest stage of scintillator machining:
- Send on PowerPoint slides on scintillator blank requirements from Harry Barnett.
- Obtain blanks for Datron machining.
- Discuss potential of new injection moulds as per HB's requirements.
Update Clatterbridge design and arrange experimental run.

UKRI Knowledge Transfer Partnership — no closing date.
- UKRI KTP Guidance Notes
- 12–36 months; £9million total budget.

Innovate UK Knowledge Transfer Partnerships: 2025 to 2026 Round Three
- KTP 2025-2026 R3 Guidance
- Total fund: £9million; £8,500 per month costs; closing date: 17th September 2025 11:30.

EPSRC Health Technologies Connectivity Awards: Round Two
- EPSRC Health Technologies Strategy
- Apply for funding to spend time in a different research or user environment to build new connections applicable to health technologies.
- Total fund: £4million; maximum award: £500,000; closing date: 2nd October 2025 16:00

@@ Line 9: / Line 9: @@
 * Shrink board to accept 1.5mm sheet spacing for Clatterbridge.
 * Update mechanical design of scintillator stack holder:
-** 3D print prototype using pillar supports.
+** Move to 4-sided readout.
-** Machined version from '''Harry Barnett''' once design fixed.
+** Potential for flex-rigid circuit design.
-** Update design with 2 sensors.
+* Contact '''Nuvia''' to discuss nest stage of scintillator machining:
-* Follow up scintillator machining:
+** Send on PowerPoint slides on scintillator blank requirements from '''Harry Barnett'''.
-** '''Martin Blackman''' (UCL Mechanical Workshop).
+** Obtain blanks for Datron machining.
-** '''Datron''' (via '''Harry Barnett''').
+** Discuss potential of new injection moulds as per '''HB's''' requirements.
-** Discuss results with Nuvia.
 * Update Clatterbridge design and arrange experimental run.