ELogs/MechanicalEngineering: Difference between revisions
< ELogs
SimonJolly (talk | contribs) No edit summary |
SimonJolly (talk | contribs) No edit summary |
||
Line 11: | Line 11: | ||
# Install Thorlabs optical breadboard in base of case. | # Install Thorlabs optical breadboard in base of case. | ||
# Cut out window at each end of case | # Cut out window at each end of case for mylar window installation. | ||
#* Max width 20cm. | |||
#* Bottom of window level with optical breadboard. | |||
#* Top of window flush with handle support struts. | |||
# Cut out 2 windows for 2-gang patch panels, 1 per side. | |||
# Cut out 2 windows for 1-gang patch panels, 1 per end. | |||
# 3D print frames for mylar windows | |||
== Completed == | == Completed == |
Revision as of 17:20, 20 September 2022
Electronic Log for Mechanical Engineering
To Do
Proton Therapy
Medium-sized Peli case
- Due date: 20th October
- Currently in Simon's office next to radiator.
- Install Thorlabs optical breadboard in base of case.
- Cut out window at each end of case for mylar window installation.
- Max width 20cm.
- Bottom of window level with optical breadboard.
- Top of window flush with handle support struts.
- Cut out 2 windows for 2-gang patch panels, 1 per side.
- Cut out 2 windows for 1-gang patch panels, 1 per end.
- 3D print frames for mylar windows
Completed
2022
- September
- Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs
- August
- Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.
- July
- Created CAD models for internal components including:
- Scintillator holder.
- 2x Side Vice faces.
- 1x Front Vice face.
- Cover for beam entry point.
- These were printed soon after.
- Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson.
- Machined two special 1/4-20 UNC screws for camera mount.
- Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel.
- June
- Initiated design of large Peli Case. Received Lab scissor jack used to mount camera.
- May
- CAD Prototype a sliding system to mount multiple scintillator holders into a case
- February
- Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped
2021
- November
- Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea
- June
- Prepare scintillator sheets to be adhered together using standard primer