ELogs/MechanicalEngineering: Difference between revisions
< ELogs
SimonJolly (talk | contribs) No edit summary |
SimonJolly (talk | contribs) No edit summary |
||
| Line 5: | Line 5: | ||
=== Proton Therapy === | === Proton Therapy === | ||
| Line 33: | Line 20: | ||
; February : Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped | ; February : Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped | ||
; July : Created CAD models for internal components including: | ; July : Created CAD models for internal components including: | ||
:* Scintillator holder. | :* Scintillator holder. | ||
:* 2x Side Vice faces. | |||
:* 1x Front Vice face. | |||
:* Cover for beam entry point. | |||
: These were printed soon after. | |||
: Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson. | |||
: Machined two special 1/4-20 UNC screws for camera mount. | |||
: Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel. | |||
These were printed soon after. | |||
Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson. | |||
Machined two special 1/4-20 UNC screws for camera mount. | |||
Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel. | |||
=== 2021 === | === 2021 === | ||
Revision as of 15:36, 20 September 2022
Electronic Log for Mechanical Engineering
To Do
Proton Therapy
Completed
2022
- September
- Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs
- August
- Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.
- June
- Initiated design of large Peli Case. Received Lab scissor jack used to mount camera.
- May
- CAD Prototype a sliding system to mount multiple scintillator holders into a case
- February
- Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped
- July
- Created CAD models for internal components including:
- Scintillator holder.
- 2x Side Vice faces.
- 1x Front Vice face.
- Cover for beam entry point.
- These were printed soon after.
- Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson.
- Machined two special 1/4-20 UNC screws for camera mount.
- Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel.
2021
- November
- Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea
- June
- Prepare scintillator sheets to be adhered together using standard primer