Proton Calorimetry/Experimental Runs/2018/Mar23: Difference between revisions

Revision as of 10:36, 28 March 2018

Beam tests of the UCL single module at medAustron.

The tests were carried out with an energy of 252.7 MeV with a 5 second beam spill and a range of intensities.
No collimators were used at any point.
The setup consisted of:
- 2" Hamamatsu R13089-100-11 PMT with negative HV active divider base (made by Hamamatsu)
- coupled with Eljen optical gel to a
- 3 cm x 3 cm x 45 cm cuboid ENVINET standard scintillator wrapped in two layers 6 um (each) of Mylar
The "pensioner" 5 dynode stage PMT was also briefly tested, but no sensible data was able to be acquired.
The digitiser always operated in Self Trigger mode.
Differences since last medAustron test beam:
- Short cables used for signals and SMA instead of BNC, controlling the acquisition remotely.
- Tests carried out at a range of HVs.
Working directory where digitiser data is stored:

C:\Users\abf\Desktop\digitiser_data\medAustron\mar18\ham

Run number	High Voltage, V	PMT Current, uA	Beam Intensity	Rate (Measured on Digitiser)	Digitiser Settings
N/A	-900	150.1 (beam off)	N/A	N/A	DC Offset: 0, Rec. Length: 396 ns, Threshold: 40 LSB, Gate Offset: 1 ns, Long Gate: 396 ns, BL Mean: 8 ns, Charge. Sensitivty: 20 fC/LSB, Pre-trigger: 9 ns

@@ Line 13: / Line 13: @@
 * The "pensioner" 5 dynode stage PMT was also briefly tested, but no sensible data was able to be acquired.
 * The digitiser always operated in '''Self Trigger''' mode.
+* Differences since last medAustron test beam:
+** Short cables used for signals and SMA instead of BNC, controlling the acquisition remotely.
+** Tests carried out at a range of HVs.
 * Working directory where digitiser data is stored:
 '''C:\Users\abf\Desktop\digitiser_data\medAustron\mar18\ham'''