Proton Calorimetry/Meetings/2025/03/04: Difference between revisions

Latest revision as of 17:20, 25 March 2025

Joe Bateman, Sonia Escribano, Matt Warren, Simon Jolly, Raffaella Radogna (via Teams)

Further analysis of the 5 Gy SOBP Simulations with varying the input parameters between the QuADProBe and DICOM
Gamma analysis of all QuADProBe compared to all DICOM distributions
Have data from Tony for 5x5 box fields but need to figure out how to process it with script
Joe, Simon, Sonia and Raffy met with Blake Leverington from Heidelberg Uni physics department to discuss scintillating fibre monitor - Blake is willing to forward details of DAQ system electronics

Raspberry pi’s all in argon one v3 cases
All have been tested with nexys board and usb connection to an old revc board and all work
Setting up on UCL network - to have static or dynamic IP address
Put old raspberry pi 4 stuff in d26
Box field and SOBP analysis
- Run 53 3x3 box field
- Highest energy is partially cut
Run 59 and run 60 5x5 box fields data not so great, on lower energies photodiode 33 skews fits, however if manually scale down fits improve
New calibration method
- live display averaged at 25 hz
Calibrate live - everything in one, separate into two files and fit each side individually
Calibrating post - same but creating file
Fitting of each calibrated file done individually
Note in header of calibrated and fitted data which side it is for

@@ Line 8: / Line 8: @@
 === [[Matt Warren]] ===
-- zMod boards don’t work
+* zMod boards don’t work
-- Connected two supplies that weren’t supposed to be connected
+* Connected two supplies that weren’t supposed to be connected
-- Zero ohm resistor connects power supply to ground
+* Zero ohm resistor connects power supply to ground
-- Shorting between 1.8V and 3V supplies
+* Shorting between 1.8V and 3V supplies
-- Still shorting even when pulling all components off the board
+* Still shorting even when pulling all components off the board
-- Only 4 places where power plane needed
+* Only 4 places where power plane needed
-- Going to try and separate connection between top layer and via
+* Going to try and separate connection between top layer and via
-- And isolate 4 connections and wire directly to input
+* And isolate 4 connections and wire directly to input
 === [[ELogs/RaffaellaRadogna|Raffaella Radogna]] ===